Tile popping is a common problem. Tile popping often occurs due to several things, among others, because the load on the floor is too heavy so that the tile is curved, very strong vibrations, cracks in concrete or foundation. The other most common cause is the expansion of the air under the tiles caused by a non-solid cement or incorrect installation. The use of manual mortar or done by uneven manpower can accelerate the lifting of ceramics when there is a shift in the soil. The characteristic feature is the surface of the floor is not flat and when stepped on the floor down. Floors also often experience problems due to weather changes, which is usually caused by land shifts. When there is a shift of surface soil, usually ceramic floor coating lifted. Another influential factor is the unstable quality of the ceramic adhesive. The raised floor is very annoying. In addition to a loud voice, ceramic fragments also endanger the inhabitants of the house. The look of the room was so unfamiliar. Tile popping often occurs on the upper floors of a building. Therefore you need an expert who can fix your home floor through our website www.grandprairiefoundationrepairpros.com.
Installation of the ceramic floor is done from the center to the edge that borders the wall. Spread the floor and wall around 2 mm as space for expanding and shrinking ceramics. Expanding and shrinking space is useful when the ceramic expands because the magnitude of the volume can still be accommodated by the distance so that the floor will not lift. Installation of ceramics should last after the concrete is depreciated / after stabilization of the concrete structure. Please note the loss of ceramics after installation of approximately 3 months to 3 years, then this is not due to ceramics, but the deformation of the floor. In the gap between the ceramic and the wall can also be fitted with rubber or foam pads to make the floor look more presentable. Because of its nature, rubber or foam will be able to accommodate the magnification of the volume produced when the ceramic expands.
Things to consider also in the installation of ceramics is grout. In the past, people used a mixture of cement and sand to fill the gap between ceramics. Because it looks less attractive then used white cement or dye. This type is widely used by people because they generally think the material is the right material to fill the grout. Fillers of cement and sand are not without problems. Cement is brittle so that the relationship between ceramics becomes stiff. If there is movement at the time of expansion, the relationship between ceramics cannot keep up with the changes. As a result of grout filler easily cracked.